Inle – Panasonic QUICKDRAW MC-V7377 User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

The hose located on the back of the vacuum cleaner carries the dirt from the nozzle

up to the dust bag. If the hose should become clogged:

1. Unplug the power cord from the outlet
before checking the airflow passages. Pull
open the suction inlet cover and check for

clogging In this area.

Cover

(Suction

Inle^

2. Disconnect the wand from the short hose
and check the wand and hose for clogging.
Plug in the vacuum cleaner and turn it on.

While running the vacuum cleaner with ttie
wand disconnected, stretch the hose in and

out to remove the clog.

3. If the clog still exists, turn the vacuum

cleaner OFF and unplug the power cord. Turn

the vacuum cleaner over, exposing the under
side. Remove the lower plate. Remove the
short hose from the housing by lifting it
straight up. Inspect the hose end and clear it
of any obstructions. Reinstall the short hose

and lower plate. See the REMOVING/

INSTALLING THE LOWER PLATE section for

detailed instructions.