Clark Synthesis TACTILE SOUND TA0.1 - Manual (Page 22)

www.clarksynthesis.com TA0.1 Amplifier 22
SPECIFICATIONS
General
Power Supply................................................................................................................100 – 240 VAC, 50/60 Hz, Auto •
Standby Current (110 VAC / 220 VAC)....................................................................................................0.12 A / 0.11 A •
Max Current (110 VAC / 220 VAC)..............................................................................................................2.4 A / 1.1 A •
Total Amplifier Efficiency..........................................................................................................................................70% •
• Dimensions (Amplifier) (W x H x D)...........................5.125 in x 2.75 in x 8.875 in (130.2 mm x 69.9 mm x 225.4 mm)
Dimensions (Remote Control Interface) (W x H x D)........................5 in x 2.125 in x 2 in (127 mm x 54 mm x 50 mm) •
Remote Control Wire Length...................................................................................................................... Approx. 4 ft. •
Weight................................................................................................................................................4.0 lbs. (1.814 kg) •
Fuse..............................................................................................................................................................T3AL 250V •
Input Section
Input Impedance...................................................................................................................................................16 kΩ •
Input Sensitivity (1 W, Input switch set to Low)...................................................................................................30 mV •
Input Sensitivity (1 W, Input switch set to High)................................................................................................100 mV •
Input Sensitivity (150 W, Input switch set to Low).............................................................................................360 mV •
Input Sensitivity (150 W, Input switch set to High)...................................................................................................1 V •
Loop Through Amplification.......................................................................................................................................x 1 •
Auto-On..............................................................................................................................................Switch Selectable •
Crossover Section
• Crossover Frequency Selection.............................................................................................................40 Hz – 400 Hz
Crossover Frequency Selection (+ 0 dB, -3 dB)....................................................................................35 Hz – 420 Hz •
Amplifier Section
• Output Power....................................................................................................................150 Watts RMS into 4 Ohms
Total Harmonic Distortion (at 1 Watt into 4Ω).......................................................................................................0.15% •
Total Harmonic Distortion (at 150 Watts into 4Ω).................................................................................................0.08% •
• Frequency Response..............................................................................................................................5 Hz to 36 kHz
Frequency Response (+0 dB, -3 dB)....................................................................................................28 Hz to 36 kHz •
Amplifier- Input/Output Panel View
2.75 in
(69.9 mm)
5.125 in (130.2 mm)
Amplifier- Side View
.875 in
(22.2 mm)
.125 in
(3.17 mm)
7.375 in (187.3 mm)
8.625 in (219.1 mm)