Clark Synthesis TACTILE SOUND TA0.1 - Manual (Page 15)

TA0.1 Amplifier 15 www.clarksynthesis.com
SETTING UP YOUR AMPLIFIER
CAUTION: Before connecting any wires or input/output lines, insure all equipment is
off and no signals are being sent from the input device.
In order to reduce the chances of accidentally damaging the amplifier or transducer, please set the
amplifier controls to the safety positions described and shown below:
Set the • On/Auto/Off Switch to the “Off” position (see photo #1)
Set the • Gain (Volume) Control to “Min” (completely counter-clockwise, see photo #2)
Set the • Input Signal Switch on the back of the amplifier to the “High” position (see photo #3)
Photo #3
Photo #1
Photo #2
!
Initial Settings Prior to Making Connections