Campbell Hausfeld PS120B - Manual (Page 5)

● Do not kink or over-bend the hose.
● Do not expose the hose to
temperatures or to pressures in
excess of those specified by the
manufacturer.
● Do not use the hose as a strength
member to pull or lift the
equipment.
● Always wear appropriate gloves, eye
protection, and a respirator or mask
when painting.
● Always work in a clean environment.
Do not aim the spray gun at any
dust or debris.
● Do not operate or spray near
children. Keep children, pets, and
visitors away from equipment and
work area at all times.
● Do not over reach or stand on an
unstable support. Keep effective
footing and balance at all times.
● Stay alert and watch what you are
doing.
● Do not operate the equipment when
fatigued or under the influence of
drugs or alcohol.
FAIlUrE TO FOllOw
ThESE INSTrUCTIONS
CAN rESUlT IN
SErIOUS INjUry
INClUDING DEATh.
5
Operating Instructions and Assembly Instructions
Relieve pressure before servicing or
resting:
1. Turn the Prime/Spray Control to the
PRIME position.
2. Turn the pressure control knob to
LOW PRESSURE position (CCW).
3. Turn power switch to OFF position
and unplug the power cord.
4. With gun pointed in a safe direction,
pull the gun trigger, with the
trigger lock disengaged.
5. Engage trigger lock.
● Simply turning off the pump motor
will not relieve pressure from
system. The above procedure MUST
be followed.
FIrE Or ExPlOSION hAzArD:
●
Do not use solvents with flash points
less than 70°F (21°C) to clean this
equipment (examples of acceptable
cleaning solvents are water or
mineral spirits. A partial example list
of unacceptable cleaning solvents
are low flash napha, mek, acetone,
alcohol and toluene).
● Use only conductive or grounded
high-pressure airless paint sprayer
hoses specified by the manufacturer.
● Verify that all containers and
collection systems are grounded to
prevent static discharge.
● Do not spray pump assembly.
● Have fire extinguisher equipment
present and working.
Do not spray flammable
materials in vicinity of
open flame or near ignition
sources. Motors, electrical equipment
and controls can cause electrical arcs
that will ignite a flammable gas or
vapor. Never store flammable liquids or
gases in the vicinity of the unit.
Do not spray acids,
corrosive materials,
toxic chemicals, fertilizers or pesticides.
using these materials could result in
death or serious injury.
● Do not use fuels to clean this
equipment.
● Keep spray area well ventilated.
Keep a good supply of fresh air
moving through the spray area.
Keep pump assembly in well
ventilated area.
● Remove all ignition sources (i.e.
Static electricity, pilot lights,
cigarettes and electrical arcing).
● Airless spraying can cause static
electricity. Always ground the pump
and spraying surface. Always use a
3-wire grounded extension cord and
power receptacle. Do not use 3 to 2
adapters.
● Do not use paints or solvents
containing halogenated
hydrocarbons such as methyl
bromine, carbon tetrachloride, and
ethyl iodine.
Keep hose away
from sharp objects.
Bursting hoses may cause injury.
Examine hoses regularly and replace if
damaged.
● Check hoses for weak or worn
condition before each use, making
certain that all connections are
secure.
● Keep area clean and free of paint or
solvent containers, rags, and other
flammable materials.
TO rEDUCE ThE rISk OF INjUry:
●
Do not spray acids,
corrosive materials, toxic
chemicals, fertilizers, or
pesticides. Using these
materials could result in
death or serious injury.
Airless Paint Sprayers
www.chpower.com