Panasonic WV-BM1900 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connect the Video Output Connector (12) on the
first monitor to the Video Input Connector (11) on
the
second
monitor
with
75-ohm
coaxial
cable.
Continue until all monitors are connected.
Set the Video Termination Switch (13) of the first
and intermediate monitors at Hi-Z position. Then
set the Video Termination Switch (13) of the last
monitor to 75ii position.
3. When used with External Sync
When a non-composite video signal is connected
to the video monitor, an external composite SYNC
signal must also be connected to the video moni
tor.
•
Connect the Video Input Connector (11) on the
video monitor to the Video Output Connector of the
camera with 75-ohm coaxial cable.
•
Connect the Video Output Connector (12) on the
first monitor to the Video Input Connector (11) on
the
second
monitor
with
75-ohm
coaxial
cable.
Continue until the video signal is connected to all
monitors.
•
Set the Video Termination Switch (13) of the first
and
intermediate
monitors
to
the
Hi-Z
position.
These set the Video Termination Switch (13) of the
last monitor to the
750.
position.
-
8
-