Panasonic NI-N50NR - Manual (Page 8)

1. Fill the iron as described in "HOW TO FILL”
2. Set the iron vertically and make sure the temperature
selector dial is set to OFF.
Plug the AC cord into the electrical outlet
3. Set the temperature selector dial to the " “
indication area.
4. preheat the iron until the indicator light goes out,
usually about 1-2 minutes.
5. Simply pump the jet of steam button when it is desired.
But pump the jet of steam button several times before
using for the first time at each ironing session.
6. Allow at least 5 seconds between uses of let of steam
to prevent water spotting. Use a press cloth if necessary.
VERTICAL STEAM(NI-N50NR Only)
To get better results when using vertical Jet of steam,hang
the garment on a clothes hanger. Curtain and drapes may
also be steamed once they're hung. Hold the iron away
from your body close to but not touching the fabric. Pull
the fabric tight with your free hand and pump the Vertical
steam button (Jet of Steam Button) at 5*second intervals
as you pass the iron over the wrinkled fablic.
WARNING.
Never iron clothes on the body or point your iron at anyone
when steaming.
Keep hands and body away from steam areas while using
vertical steam feature.
SELF-CLEANING
With the self-cleaning feature you can flush out mineral residues from the steam generating
chamber and the steam vents--refreshing your iron each time for a longer steaming life.
It is very important to operate the self-cleaning feature after each steam ironing to prevent
mineral accumulations from hardening.
1. Check water level. Water level should be at the 1/2 full. When water level
is below 1/2 full, fill with water according to the instruction in "How to Fill',
2. Preheat at "6" setting, {in about 1-2 minutes)
Makes sure that the steam button is in the Dry position.
3. Set the dial to off and remove the Ac plug.
4. Hold the iron horizontally over the sink.
5. Pump the "Jet of Steam" button quickly (at least 3
times per second) about 20-30 times.
-8-