Panasonic MC-V7407D - Manual (Page 20)

REQUIESIÜF
A
WARNING
Electrical Shock or Persor\a! Injury Hazard.
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do so
could result in electrical shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it-yourseif soiutions for minor performance
probiems. Any service needed, other than those described in these
Operating Instructions, shouid be performed by an authorized service
representative.
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
Cleaner will
not run.
1. Unplugged at wall outlet. 1. Plug in firmly. Push ON-OFF
switch to ON.
2. Tripped thermal protector. 2. Reset thermal protector.
3. ON-OFF switch not turned on. 3. Push ON-OFF switch to ON.
4. Tripped circuit breaker/blown
fuse at household service panel.
4. Reset circuit breaker or replace
fuse.
Poor job of dirt 1. Full or clogged dust bag. 1. Change bag.
pickup.
2. Agitator On-Off selector in
wrong position.
2. Set in the correct position.
3. Clogged hose or nozzle. 3. Clean hose or nozzle area.
4. Hose not inserted fully. 4. Insert hose.
5. Worn agitator. 5. Replace agitator.
6. Hole in hose. 6. Replace hose.
7. Dust cover improperly installed. 7. Properly install dust cover.
Agitator does
not turn.
1. Tripped agitator overload
protector.
1. Reset agitator overload protector.
2. Tripped agitator thermal protector. 2. Reset agitator thermal protector.
3. Vacuum in full upright position. 3. This is normal. Agitator will not
rotate in full upright position.
4. Agitator On-Off selector in
off position.
4. Push selector to ON.
Dust escapes 1. Bag improperly installed. 1. Properly install bag.
the paper bag.
2. Bag torn. 2. Replace bag.
Light will 1. Burned out light bulb. 1. Replace light bulb.
not work.
Dirt sensor will 1. Dirty optic cells. 1. Clean optic cells.
not work.
- 2 0 -