Panasonic WX-RP410 - Manual (Page 13)

FREQUENCY SETTING
Group Description
To use the transmitters by utilizing a maximum 6 channels
in the same area, a specified group number should be
chosen by the Group Selection Switch.
Choose one group number from 1 - 6 in the same area.
• When using Group 1, 2, 4 or 5, 6 channels can be
used.
• When using Group 3 or 6, 5 channels can be used.
If the specified channel can not be used in the same
group, use the channel of an other group (include * and :}
not effected by the interference. (Confirm the frequency)
Notes:
1. Be sure to use this receiver and the transmitter at
the same frequency.
2. Receivers which are used in the same area should
be set to the same group number and each Channel
Selection Switch set to a different number.
In case that radio interference is encountered,
change the frequency immediately.
The distance between groups may be changed by
various conditions.
3.
4.
How to set the frequency
1. Set the Group Selection Switch (2) of this transmitter
to the same number as the one of the receiver.
2. Set the .Channel Selection Switch (3) of this
transmitter to the same number as the one of the
receiver.
Note :
Use the Miniature Screw Driver (provided) to
set the above switches.
3. Turn on the power of the receiver only.
Set the receiver to the desired frequency.
Confirm that the Receiving Level Indicator on the
receiver lights off.
Notes :
1. If the Receiving Level Indicator lights with
turning on the power of the receiver and turning
off the power of transmitter, this unit will be
interfered by the external radio wave,
2. Do not use the transmitters having adjoining
channels in the different group within 600 ft,
(200m) to avoid the interference.
- 10 -