Panasonic MC-V7348 User Manual
Panasonic, Mc-v7348, Operating instructions instrucciones de operación
Table of contents
Document Outline
- Panasonic
- Operating instructions
- A
- A
- A
- A
- AVERTENCIA
- A
- CUIDADO
- AVERTENCIA
- AVERTENCIA
- Guarde estas instrucciones
- >- Remove handle screw
- >- Insert handle
- Some tools may already be stored on vacuum cleaner
- Place hose in front of handle on hose holder
- Store other wand, with dusting brush on top, in round front slot of toot holder
- Refer to PARTS IDENTIFICATION section for tool location
- >- The nozzle of your Panasonic upright vacuum cleaner automatically adjusts to any carpet pile height
- Edge cleaning feature provides for improved cleaning of carpets near walls and furniture
- Automatically trips to prevent the motor from overheating when a clog occurs or when dust bag needs changing
- The vac guage detects when dust bag needs changing or the vacuum is clogged
- If dust bag is full, change bag according to CHANGING DUST BAG section
- то OPERATÉ^EEAÑER
- >■ Ensure ON-OFF switch is OFF
- 1)
- 4)
- ALWAYS place carpet-bare floor selector in BARE FLOOR (TOOLS) positon when using tools
- The tools can be attached to hose, wand or crevice tool
- Place all tools and hose back in the same manner as shown in TOOL STORAGE
- TOOL USE / Liso de herramientas
- 3)
- >- Before servicing any parts, disconnect vacuum from electrical outlet
- >■ Remove lower plate
- >■ Only use a bulb rated 130 V AC-15 Watts or less
- Replace belt whenever a burning rubber smell caused by excessive slippage occurs
- Remove worn or broken belt
- Clean agitator after every five uses and every time the belt is replaced
- Unplug cord from wall outlet
- DO NOT clean tools in dishwasher or clothes washer
- The hose located on the back of the vacuum cleaner carries the dirt from the nozzle up to the dust bag. If the hose should become clogged:
- >- Unplug vacuum
- A
- A