Notice, For united kingdom only), How to replace the fuse – Panasonic KV-SV50 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/652440/4/background.png)
Notice
For your safety please read the following text carefully.
(For United Kingdom only)
This appliance is supplied with a moulded three pin mains plug for your safety and convenience.
A5 amp. fuse is fitted in this plug. Should the fuse need to be replaced please ensure that the replacement
fuse has a rating of 5 amps, and that it is approved by ASTA or BSI to BSl 362. Check for the ASIA mark
or the BSI mark ^on the body of the fuse. If the plug contains a removable fuse cover you must ensure that
it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a replace
ment cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer.
If the fitted moulded plug is unsuitable for the socket outlet in your home then the fuse should be removed
and the plug cut off and disposed of safely.
There is danger of severe electrical shock if the cut off plug Is inserted into any 13 amp. socket.
If a new plug is to be fitted please observe the wiring code as shown below. If in any doubt please consult a quali
fied electrician.
WARNING : This appliance must be earthed.
IMPORTANT : The wires in this mains lead are coloured in accordance with the following code.
Earth
Neutral
Live
As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows.
Green-and-Yellow
Blue
Brown
The wire which is coloured Green-and-Yellow must be connected to the terminal in the plug which is marked
with the letter E or by the Earth symbol i or coloured Green-and-Yellow.
The wire which is coloured Blue must be connected to the terminal in the plug which is marked with the letter
N or coloured Black.
The wire which is coloured Brown must be connected to the terminal in the plug which is marked with the let
ter L or coloured Red.
How to replace the fuse :
Open the fuse compartment with a screwdriver and replace
the fuse.
BiiEjMÌD
The product should be used only with the power cord and interface cable that are sup
plied by the manufacturer.
[^jQiaæte
Le produit ne devra être utilisé qu'avec le cordon d'alimentation et le câble d'interface
fournis par le fabricant.
Dieses Gerät darf nur mit dem Netzkabel und dem Schnittstellenkabel verwendet
werden, die vom Hersteller geliefert werden.