Panasonic KV-SV50 - Manual (Page 10)

Installing the Document Tray and the Exit Tray
1
2
Align both sides of the tray with the docu­
ment feed slot, then firmly insert the tray
into the slot using both hands until a "click"
is heard.
Caution :
Before installing the document tray, be sure
to perform the following procedure.
© Connect the power cord.
@ Turn the power switch on and initialize
the unit for approximately 15 seconds.
Insert both ends of the exit tray into the
holes at the sides of the document exit slot.
3
Removing the exit tray
Slightly bend the exit tray while pull­
ing it toward you, as shown in the
figure.
Remove the protective cover from the adhe­
sive strip on the exit tray sheet.
Place the exit tray sheet into the rear of the
document exit area and attach to the exit
tray.
Document exit
slot
Exit tray sheet
Adhesive tape
(Opposite side
of the exit tray
sheet)
Exit tray
Place the end of the exit tray sheet ("X”
marked area) until it touches the cabinet
under the document exit slot and attach
this sheet to the exit tray.
Removing the document tray_______
Grasp the document tray as shown
in the figure, then lift slightly and
pull it toward you.
10