CLIFFORD 50x - Manual (Page 11)

How to interpret the chirps and indicator light flashes
When you use the remote, the system responds with chirps and indicator light flashes:
Chirps and flashes Meaning
1 Your system is disarmed
2 Your system is armed
2 and then 4
Armed but there is a door open or the sensor is malfunctioning
(see Smart AutoTesting on page 14)
3
Disarmed but there was an intrusion attempt whilst you were away
(see Smart prior intrusion attempt on page 8)
4 Armed but the bonnet or boot is ajar (see Smart AutoTesting on page 14)
How to interpret the LED status indicator
The LED on your car’s dashboard or console will inform you of the system status:
LED Condition Meaning
Off System is disarmed and in normal operating mode
On Valet or programming mode.
Flashing The AutoImmobiliser is engaged and/or the system is armed and protecting your vehicle
Pause between flashes Either a malfunction (see page 14) or an intrusion was attempted (see page 8)
AutoArming
If you forget to remotely arm, the system will automatically arm itself 30 seconds
after you park the vehicle, exit, and close all the doors. For your convenience, if you
re-open any door(s) within the 30-second countdown, AutoArming will restart from
the beginning once all doors are closed. Concept 50x has these additional
AutoArming features:
n AutoArming en able/dis able: If you prefer, you may deactivate or reactivate
the AutoArming feature. See User-selectable features on pages 16-20.
n Vis ual ac knowl edg ment: Five seconds after you exit the vehicle and close all
the doors, the indicator lights will flash twice to confirm that the AutoArming
countdown is progressing. Then, 25 seconds later, the system will AutoArm.
n AutoArm & Lock: To ensure you can’t accidentally lock your keys inside the
car, the system is factory-set not to lock the doors upon AutoArming. To
change this setting, see
User-selectable features on pages 16-20.
n In stant AutoArming by pass: Prevents AutoArming when fuelling and other
times when you wish to temporarily bypass AutoArming. To activate Instant
AutoArming Bypass, rapidly turn the ignition switch to “ON” then “OFF.” You
will hear a single siren chirp to confirm that the system will not AutoArm. The
system reverts to its normal operating mode when you next start the engine.
9