Dynon Avionics EMS-D10 Pilots Users Guide - Manual (Page 39)

EMS Operation
7-6 EMS-D10 Pilot’s User Guide
Change power on alarms status: EMS > SETUP > GLOBAL > ALARM CONFIG > PWR ON ALARMS
Set this parameter to “ON” to enable alarms before engine startup. When set to “OFF”, all alarms are suppressed
whenever ALL of the following conditions exist:
 RPM less than 400
 Oil pressure less than 20 PSI
 First five minutes after master instrument power applied
All alarms are enabled when any of the above conditions are exceeded.
Note: The alarm light (if installed and configured) will flash whenever an alarm condition exists; it is not inhibited by
setting PWR ON ALARMS to OFF.
Test light/audio alarm(s): EMS > SETUP > GLOBAL > ALARM CONFIG > TEST ALARM LIGHT/AUDIO
Note: You must select an alarm to test using the UP▲/ DOWN▼
buttons. Hold SEL► to test the selected alarm.
Info Item Configuration: EMS > SETUP > GLOBAL > INFO ITEM
CONFIG►
The INFO ITEM CONFIG submenu allows you to configure a variety
of different sensors as simple analog bars, on/off contacts, or text
items.
The first four info items are displayed on the EMS Main Page. Info
items 1 and 2 at the top and info items 3 and 4 at the bottom. The other
four info items are located on the Aux/Times Page and are numbered 5