Dynon Avionics RV-6 Roll Kit - Manual (Page 3)

DYNON AVIONICS
Servo Mounting Instructions – RV-6 Roll Kit 2
101046-001 Rev F
SERVO MOUNTING INSTRUCTIONS – RV-6 FUSELAGE ROLL KIT
Kit Contents
Dynon Part # QTY Part Description
100836-000 2 Large Male Rod End
100866-000 1 RV6 Roll Bracket
100867-000 1 RV6 Roll Plate
100966-005 1 Aluminum Pushrod Tube - 7.5"
100975-002 2 AN315-4R Jam Nut
100976-007 4 AN365-832A Nylon Insert Locknut
100976-011 2 AN365-1032A Nylon Insert Locknut
100977-000 2 AN970-3 Large Flat Washer
100978-002 4 AN960-8 Small Flat Washer
100978-003 7 AN960-10 Small Flat Washer
100979-002 4 MS35333-39 #10 Internal Star Washer
100980-008 4 MS24693-50 Countersunk Machine Screw
100981-000 4 AN3H-3A Bolt - 3/8"
100981-005 1 AN3H-10A Bolt - 1"
100981-014 1 AN3H-21A Bolt – 2 1/8"
100982-002 1 Aluminum Spacer - 0.600"
The RV-6 fuselage roll servo mounting kit includes a mounting bracket, strengthening plate,
pushrod linkage, and all of the required fasteners to mount the servo and properly link it to the
aircraft control system. All Dynon-supplied parts are illustrated in dark grey to distinguish them
from existing aircraft hardware. Refer to the drawing to locate the servo mounting bracket in the
aircraft. Dynon currently supports a fuselage-only roll install for the RV6. The bracket and servo can
be installed under either the pilot or passenger seat.
Decide whether the bracket will be installed using the recommended method of securing through
the floor (fuselage skin) or bolting to the rib. The alternate rib fastening method requires the installer
to supply additional fasteners. Dynon has supplied a strengthening plate that will sandwich the
aircraft skin when installed in the recommended manner. Use the bracket as a template for drilling
and refer to the drawing for dimensions. Rivet nuts can be attached to the bracket, or simply use the
supplied MS24693-50 screws through AN960-8 flat washers and AN365-832A lock nuts as
illustrated. This installation method should place the fuselage skin holes and plate underneath the
landing gear fairing in an RV6A.
With the bracket in place, the servo can be installed. We recommended that all 4 of the AN3H-3A
bolts be installed with the MS35333-39 star washers and AN960-10 flat washers to secure the servo
to the bracket. All AN bolts supplied by Dynon have drilled heads for use with safety wire.