Dynon Avionics D2 Wi-Fi Troubleshooting Guide - Manual (Page 6)

D2 Wi-Fi Troubleshooting Guide Revised September 7, 2013 Page 6
iHUD Remote
iHUD Remote is an iPhone application that can also be run on
the iPad tablet device. This application is configurable to use
either TCP or UDP protocol. UDP is strongly recommended in
order to allow multiple devices to take advantage of the AHRS
data from the D2 simultaneously. GPS ground speed, G-load,
attitude, GPS altitude, rate of climb and the D2 battery level can
all be monitored with this application.
To set up iHUD Remote to work with the D2, tap on SETTINGS at the bottom right then on “Wi-Fi
Settings & Signal / Compass Source” to configure the application.
Tap on UDP and accept the default Port: and IP: values provided.
Magnetic Compass Heading, Speed and Altitude information can be obtained from the D2 by tapping on
M AHRS and AHRS Air Data buttons. This data is derived from GPS information by the D2, not from Air
Data. The AHRS buttons refer to information obtained from the D2 whilst the GPS buttons refer to the
internal iPad GPS.
Tapping on M AHRS will provide a magnetic compass heading from the D2 whilst T AHRS will provide a
true compass heading from the D2.
When finished, tap on the iHUD display button to return to the attitude display.