Figure 2 flat bottom gauges – Dillon U Force Gauge User Manual
Page 2
Weigh Bar
®
is a registered trademark of Weigh-Tronix Inc
02/24/03 UNIVERSL.P65 PN 16944-0013E e1 Printed in USA
Dillon
A division of Weigh-Tronix Inc.
1000 Armstrong Dr.
Fairmont, MN 56031 USA
Telephone: 507-238-4461
Facsimile: 507-238-8258
e-mail: [email protected]
www.dillon-force.com
Force Measurement Products & Systems
Capacities intended for operation on a flat surface are machined WITHOUT a
recess in the bottom half of the deflection beam. Load must be applied at
point "F" as shown in Figure 2.
Figure 2
Flat bottom gauges