ClearSounds A1600E - Manual (Page 12)

12 – ENGLISH
If successful, the handset settings will be reset to the initial
factory settings, otherwise the settings will remain. After
resetting, the handset will return to standby mode.
█
Base Selection
This function allows you to select a base from those already
registered to the handset. To select a base:
1. Press under the word Menu on the screen to display
the main menu list.
2. Press up or down to scroll to HS Settings and then
press under the word Select.
3. Press up or down to scroll to Select Base and then
press under the word Select.
4. Press up or down to select the base you want and
then press under the word Select. If you select a
non-existent base, the handset will sound a warning tone.
5. The display will show Searching and then BS Selected.
The display will automatically return to the previous
menu screen.
█
Out of Range Alarm
This function allows you to know when the handset is out of
range of the base, and a beep will sound. Your ClearSounds®
A1600E comes from the factory preset for Out of Range Alarm
ON. To change this setting:
1. Press under the word Menu on the screen to display
the main menu list.
2. Press up or down to scroll to HS Settings and then
press under the word Select.
3. Press up or down to scroll to Tone Setup and then
press under the word Select.
4. Press down to select Out of Range and then
press under the word Select.
5. Press up or down to select On or Off and then
press under the word Select.