C. Crane BC75XLT User Manual

Page 24

inside the battery compartment is a switch; set the unit to
either ALK or Ni-MH to match the type of battery you’re
using.
WARNING! Non-rechargeable batteries can get hot or

burst if you try to charge them.

CAUTIONS:

• When

flashes in the display and the scanner

beeps every 15 seconds, recharge or replace the
batteries .

• Use only fresh batteries of the required size and

recommended type .

• Always remove old or weak batteries . batteries can

leak chemicals that destroy electronic circuits .

• Do not mix old and new batteries, different types of

batteries (standard, alkaline, or rechargeable), or
rechargeable batteries of different capacities .

Installing Non-Rechargeable Batteries
1. Make sure the power is turned off.
2. Slide the battery compartment cover off.
3. Use a pointed object such as a ballpoint pen to set the

battery selection switch inside the compartment to
ALK.

4. insert the batteries as indicated by the polarity symbols

(+ and -) marked inside the battery compartment.

5. replace the battery compartment cover.
Installing Rechargeable 2300mAh Ni-MH Batteries
You can also use two ni-MH rechargeable batteries to power
your scanner.