C. Crane CCRADIOplus Platinum - Manual (Page 14)

Page 14 CCRadio plus
Radio Operation
The Lock switch can be used when transport-
ing the radio to prevent accidentally turning it
on. When the switch is pushed up you will
see the Lock symbol appear on the
display. It can also be used to disable all
functions of the radio when it is turned on.
Push the switch down to release the
lock for normal operation.
You can use a stereo or mono headphone with a 3.5 mm plug. When
you insert the headphone plug, the speaker is disconnected. This radio
delivers FM in stereo through the headphones.
Once in a while glitches may occur on any portable digital radio. This
can be caused by static electricity, unusual key strokes or a power dis-
ruption. If this happens, use the end of a paper clip or ball point pen and
push it into the hole briefly to reset the radio. You will lose the clock
time and all the stations stored in memory when the radio is reset.
Lock
Switch
Headphone
Jack
Reset Button
Bottom View
of CCRadio plus
Display Light on AC Power
When the radio is plugged into AC power, the display light will always
be on unless you turn it off. The special green LED bulbs last
about 100,000 hours and use very little electrical energy. If you
want to turn off the display light, press the Light button. Refer to
page 5 for button identification.
Display Light on Batteries
When batteries are used the display light can be turned on by
pressing the light button. The display light automatically goes off
two minutes after the last time you press any button.
Right Side View
LOCK SWITCH
HEADPHONE JACK
RESET BUTTON
DISPLAY LIGHT