Sangean UCR-100 (V1) - Manual (Page 6)

5
Your clock radio is designed for substructure-installment under
shelves, kitchen cupboards etc. The speaker must point
downwards and be unobstructed to offer the best possible sound
quality. Please don’t install this appliance close to stove or other
cooking appliance so that is not subjected to damaging steam.
The clock radio is to be mounted in the desired position with the
bracket , on the appliance. To simplify the installment,
the bracket can be removed from the appliance by loosening the
two knurled screws and from the appliance. We recommend
using the following helpful trick for the installment, to enable the
mounting of the bracket without having to measure:
1. Stick a piece of industrial strength adhesive tape on the left and
right sides of the bracket.
2. Press the appliance against the surface where it is to
be installed.
3. Without letting go of the appliance, remove the two holding
screws and and remove the radio carefully from the
bracket .
4. Now you can screw on the bracket with the four screws.
5. Slide the radio onto the bracket and tighten the knurled
screwdriver to tighten screw and .
6. Completely unwind the short-wave cable antenna.
Fasten the antenna onto the underside of the cupboard or
shelf with a reliable adhesive tape.
Installment material (with delivery):
4 short screws
4 long screws
4 spacers
A
A
B
B
B
C
C
C