Sangean PR-D4 (R2) - Manual (Page 9)

8
Recalling stations from preset memories
1. Press the Power button to turn on the radio.
2. Select the required waveband.
3. Momentarily press the required Preset button, the preset number
and station frequency will appear in the display.
Setting the radio alarm
When the radio alarm is selected, the radio will turn on and play the
chosen radio station at the chosen alarm time. The radio alarm will
continue for one hour unless turned off by pressing the Power button.
Press the Power button whilst the alarm is activated will cancel the
alarm for 24 hours.
Note:
Radio alarm can be activated only until both radio alarm time and
radio alarmed station are set. Radio alarm will be automatically
switched buzzer alarm when the radio is in low battery status or the
selected radio alarm station signal is too weak.
a. Setting the radio alarm
1. The radio alarm can be set when radio is on or off.
2. Press and hold the radio alarm button until the radio alarm symbol
flashes on the display followed by a beep.
3. Press the Tuning up/ down button to select the desired hour and
press the Time setting button to confirm hour setting.
4. Press the Tuning up/ down button to select the desired minute and
press the Time setting button to confirm minute setting.
5. While radio alarm symbol is flashing, press the Tuning up/ down to
select desired wake-up band and station, then press the Time
setting button to confirm the selection. Radio alarm setting is
now completed.
GB