Sangean Package PR-D7 (R2) - Manual (Page 9)

8
GB
Using the supplied AC power adaptor
The supplied AC adaptor is 2 Volts DC output 500 mA center pin
positive.
. Insert the adaptor plug into the DC IN socket on the left hand side
of the radio.
2. Plug the adaptor into a standard 3A mains socket outlet. Whenever
the adaptor is plugged into the radio and switched on the mains,
the batteries are automatically disconnected.
If the adaptor is plugged into the radio but not the mains is not
switched on then the radio will run from the batteries if fitted.
The AC adaptor should be disconnected from the mains supply and
the radio when not is use.
Setting the clock
. Clock can be set either the radio is power on or off.
2. Display will show “ - : - - “ when the batteries are installed when
the radio is connected to the mains supply.
3. Press and hold the button for more than 2 seconds, display
will flash time set symbol and also the hour digit, followed
by a beep.
4. Press Tuning Up/Down to set required hour.
5. Press button again, the minute digits will flash.
6. Press Tuning Up/Down to set required minute.
7. Press button to complete time setting.