Sangean Package PR-D7 (R2) - Manual (Page 11)

0
GB
Manual tuning / station searching
. Press the Power button to turn on the radio.
2. Select the required waveband by pressing the Band button.
Adjust the antenna as described above.
3. A single press on either the Tuning Up or Down button will change
the frequency in the following increments:
FM: 50 or 00 kHz
AM (MW): 9 or 10 kHz
4. Press and hold either Tuning Up or Down button until the frequency
in the display begins to change rapidly. Release the button.
Your radio will search the selected waveband and stop automatically
when it finds a station of sufficient signal.
5. Rotate the Volume control to get required sound level.
6. To turn off the radio, press the Power button.
Display will show off.
Storing stations in preset memories
There are 5 memory presets for each waveband.
. Press the Power button to turn on the radio.
2. Tune to a required station using one of the methods previously
described.
3. Press and hold down the required preset until the radio beeps.
The preset number will appear in the display and the station will
be stored under chosen preset station.
4. Repeat this procedure for the remaining presets.
5. Stations stored in preset memories can be overwritten by following
above procedures.