Cary Audio Design CD 200 - Manual (Page 5)

OPERATION
Signal output connection is made via the output jacks on the rear panel of the CD-306/200. The
analog or digital output interconnect cables should go to the input connections on the
accompanying preamplifier or Digital to Analog processor. The choice of high quality
interconnect cable is important and we recommend them highly. Your audio dealer will have the
proper cables in stock for this purpose.
3.1 Operation
Your new CD-306/200 CD Transport/Processor is ready for operation after interconnect cables
have been installed.
3.2 Power On and Stand-By Mode
When your CD-306/200 is connected to the power supply, the unit will switch to the Stand-By
mode automatically. This is a convenient feature for users to turn the power on with the remote
control.
3.3 Front of player
POWER BUTTON: switches the power ON and OFF.
DIGITAL SAMPLE-RATE COVERTER BUTTON: by selecting “on” the output data is 96kHz/
24bit. Selecting “off” the output data is
44kHz/16bit or matching input data-rate.
ANALOG SAMPLE-RATE COVERTER BUTTON: For selection of internal D/A sample rate.
The output data of the “ON” setting is
192kHz/24bit and the data rate of the
“OFF” setting is matching the input data.
REMOTE SENSOR: Receives the signals from the remote control.
DISPLAY: Gives information on the functioning of the player.
PLAY BUTTON: Starting play. Interrupting. Resuming play
STOP BUTTON: Stopping play.
PREV. and NEXT BUTTON: Selecting another track during play.
Selecting a track to start play with.
OPEN / CLOSE BUTTON: Opening and closing the CD compartment. The compartment also
closes when the front is pressed briefly.
CD BUTTON, AES/EBU BUTTON, COAXIAL BUTTON, TOSLINK BUTTON:
This switches the digital input selections.
P.4