Sangean DT-120 (R2) - Manual (Page 4)

3
Battery Installation
Battery cover is located on the back of the unit. Slide
the cover downwards to gain access to the battery
compartment. Insert two AAA (UM-4) batteries into
the compartment. Make sure that the battery is
positioned in accordance with the indicated diagram.
Replace cover.
Note:
1. You can always monitor the battery power from LCD
display battery icon. When battery power becomes
very low and unable to operate the radio, low
battery indicator will flash together with an “E“
appears on the LCD display. The radio will shut off.
2. Make sure to replace the batteries within 3 minutes.
This will prevent any memory presets from being
lost during the battery replacement.
Time setting
Press and hold the Time setting button for 2 seconds.
Hour will flash, press the Tuning up/down button to
choose your desired time and then press the Time
setting button to select the digit. After completion of
hour setting, minutes digit will then flash, following
above setting steps to set minute.