Parts used, Assembly of the muffler, Installation of air filter – OFNA Racing OB4 RTR User Manual
Page 30: Assembly of the muffler onto chassis and fuel tube
INSTALLATION OF THE SHOCK ABSORBER
( Front and Rear )
Assembly of the right and lefthand side
are the same.
Assembly of the right and lefthand side
are the same.
* Push ball & socket into the
ball end of the shocks. Note and
start at the larger hole.
* Push ball & socket into the
ball end of the shocks. Note and
start at the larger hole.
3 x 10mm Screw x4
PARTS USED
37955
6mm Alum.
Ball & Socket x4
3 x10mm
Screw
37955
6mm Alum.
Ball & Socket
2mm
Plastic Washer
* Take 2mm plastic washer from shock plastic parts.
* Take 2mm plastic washer from shock plastic parts.
* Take 2mm plastic washer from shock plastic parts.
3 x10mm
Screw
* Snap onto 4mm ball & socket .
37955
6mm Alum.
Ball & Socket
2mm
Plastic Washer
3 x 10mm
Screw
* Snap onto 4mm ball & socket .
37955
6mm Alum.
Ball & Socket
3 x 10mm
Screw
37955
6mm Alum.
Ball & Socket
2mm
Plastic Washer
49
49
3x10mm
Flat head
Screw
3mm
Flange Screw
* Plug antenna pipe
into antenna post.
Antenna pipe
4x4mm
Set Screw
* Use 4x4mm set screw to
hold the muffler.
* Inset fuel tube into
the pressure of the muffler
and fuel tank.
* Use fuel tube connect
fuel tank and carburetor.
Fuel Tube
30491
Muffler Stay
32890
Muffler
Cable Tie
Cable Tie
ASSEMBLY OF THE MUFFLER
10079
Pressure Nipple
38163
Silicon Tube
46
46
Strap
INSTALLATION OF AIR FILTER
39473
Holder with foam disc.
39474
Air Filter, refills
Carburetor
* Insert air filter
into air filter holder
* Apply filter oil to disc
before using.
* You secure filter to Carb.
Do not run engine without
filter.
47
47
ASSEMBLY OF THE MUFFLER ONTO CHASSIS AND
FUEL TUBE
48
48
15mm