Cobra Electronics XRS 9675 - Manual (Page 10)

Program/Mute Button
Select/Dim Button
Set/City
Button
Settings
Intro Operation Customer
Assistance Warranty
Notice
Secondary Icons
Your Detector
Nothing comes close to a Cobra ® 15
Settings
Intro Operation Customer
Assistance Warranty
Notice
Secondary Icons
Your Detector
14 English
Tone Visual Display
One beep IntelliMute not set
Please try again
One beep IntelliMute Off
NOTE
If the unit is unable to sense usable pulses within three seconds or if you do
not set a rev point within 20 seconds of beginning these steps, IntelliMute will
indicate an error and automatically turn off.
Intro Operation Customer
Assistance Warranty
Notice
Main Icons
Secondary Icons
Set Intel... Press SET...
Setting IntelliMute RPMs
Intelli
Mute
Set!
IntelliMu...
Please tr...
IntelliMute
Not Set
Intelli
Mute
Off
IntelliMute Off
To set the IntelliMute Activation Point using Program Mode
(See page 7 for instructions on using Program Mode)
In Program mode, go to Set
IntelliMute. Tone Visual Display
None Set IntelliMute
Press and release the Set/City button
to begin setting IntelliMute RPMs. Two beeps Press SET at
desired RPMs…
Rev your engine to the level you wish
to set. Rev the engine slightly above idle
and hold revs steady for two seconds. None None
At the desired rev level, press and
release the Set/City button. Three beeps IntelliMute Set!
Press and release either the
Select/Dim button to proceed to the
next user mode or the Program/Mute
button to exit the Program mode. None None
Operation Customer
Assistance Warranty
Notice Caution Warning
Installation
Customer
Assistance
What to remember while using IntelliMute
IntelliMute works with all City and Auto Mute modes.
Whenever engine revs are below the activation point, an arrow
pointing down will appear in the display. Above the activation point,
an arrow pointing up will appear.
If, for any reason, the unit stops sensing your engine’s revs,
IntelliMute will indicate an error and automatically turn off.
The rev point you set will be stored in the unit’s memory when
power is turned off and recalled each time the power is turned on.
NOTE
The rev point must be reset if you use your detector in a different vehicle.
NOTE
When initially choosing your IntelliMute activation point, a setting
of approximately 300 to 600 RPMs above idle is recommended.
You can reset the activation point at any time to fit your individual
preferences and driving style.
Setting the IntelliMute Activation Point
Your detector must be installed in your vehicle.
CAUTION
Do not attempt to set the rev point while driving.
Your vehicle should be parked and idling.
IntelliMute must be turned on before setting the activation point.
Intro Operation Customer
Assistance Warranty
Notice
in Icons
condary Icons
Intro Operation Customer
Assistance Warranty
Notice
in Icons
condary Icons
Below Activation Point
N W i h
Above Activation Point
N W i h