CLIFFORD AvantGuard III - Manual (Page 17)

What each button/channel does
Your AvantGuard III remote controls come pre-programmed so that certain channels
command certain functions. The following chart indicates what each remote control
channel number does, and how to transmit each channel number.
Factory settings of the 16 remote control channels
Transmitting
channel
number:
Causes the system to:
Press the
LevelShift
button?
How
many
times?
Press
button
number
1 arm or disarm and lock or unlock the doors no — 1
2
pop the boot* (if the system is disarmed)
AND
turn on the headlights (if the system is armed)
no — 2
3 silently arm or disarm no — 3
4
activate an optional accessory or, on some vehicles, automatically
close the windows and sunroof when you remotely arm*
no — 4
5 remotely start or shutdown the engine yes once 1
6 activate optional accessory or control a Clifford system on another car yes once 2
7 activate optional accessory or control a Clifford system on another car yes once 3
8 activate optional accessory or control a Clifford system on another car yes once 4
9 remotely enter or exit valet mode (see page 19) yes twice 1
10
remotely turn off one or both Proximity Sensor zones
if the system is armed (see page 22)
AND
turn on the AutoStart mode previously selected
if the system is disarmed (see page 29)
yes twice 2
11
remotely adjust sensitivity of the Proximity Sensor’s
passenger compartment alarm zone (see page 21)
yes twice 3
12
remotely adjust sensitivity of the Proximity Sensor’s
exterior warning zone (see page 21)
yes twice 4
13 activate optional accessory or control a Clifford system on another car yes
three
times
1
14 activate optional accessory or control a Clifford system on another car yes
three
times
2
15
remotely adjust sensitivity of the Piezo Sensor’s
primary alarm zone (see page 21)
yes
three
times
3
16
remotely adjust sensitivity of the Piezo Sensor’s
secondary warning zone (see page 21)
yes
three
times
4
* May require additional wiring.
15