Ryobi P711 - Manual (Page 12)

12
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear safety goggles or safety glasses with side
shields during product operation or when blowing dust.
If operation is dusty, also wear a dust mask.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the product when cleaning or
performing any maintenance.
OPERATION
ADDING ATTACHMENTS
See Figures 5 - 6.
The brush attachment and crevice tool attachments can be
easily snapped into place on the hand vac.

Turn off the vacuum.
 Insert the attachment into the front end of the vacuum
dust bowl, making sure the attachment is firmly snapped
into place.
When purchasing replacement brush attachment, request
recommended part number 300013088.
When purchasing replacement crevice tool, request recom-
mended part number 590113001.
Fig. 5
Fig. 6
CREVICE TOOL
BRUSH
ATTACHMENT
TO INSTALL
TO REMOVE
TO INSTALL
TO REMOVE
MAINTENANCE
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at an Authorized Service Center.