Assembly – Ryobi RLS1351 User Manual
Page 10
10
ASSEMBLy
LOOSE PARTS LiST
See Figure 2, page 17.
The following items are included with the saw:
Key
No. Description
Qty.
A
Saw Handle .........................................................1
B
Screws .................................................................2
C
Blade Wrench ......................................................1
D
Screws .................................................................4
E
Feet ......................................................................4
F
Push Stick ...........................................................1
G
Work Clamp .........................................................1
H
Fence ...................................................................1
I
Dust Bag ..............................................................1
J
Screws .................................................................2
K
Foot/Blade Wrench Holder ..................................1
Operator’s Manual (not shown) ...........................1
UNPACKiNg
This product requires assembly.
Carefully lift saw from carton and place on a level work
surface.
wARNiNg:
Do not use this product if any parts on the Loose Parts
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer instal-
lation. Use of a product that may have been improperly
assembled could result in serious personal injury.
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
The saw is factory set for accurate cutting. After assem-
bling it, check for accuracy. If shipping has influenced
the settings, take to an authorized service center.
If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
wARNiNg:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
wARNiNg:
Do not attempt to modify this product or create acces-
sories not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
wARNiNg:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
wARNiNg:
Never stand directly in line with the blade or allow hands
to come closer than 3 in. to the blade. Do not reach over
or across the blade. Failure to heed this warning can
result in serious personal injury.
NOTE: No adjustments that can made to this tool except
by an authorized service center.
TO iNSTALL ThE SAw hANDLE
See Figure 3, page 18.
Position the saw handle over the holes in the saw hous-
ing (straight side of the handle to the back).
Secure saw handle in place using Phillips screws.
TO iNSTALL ThE FOOT/BLADE wRENCh
hOLDER
See Figure 4, page 18.
Align holes in foot/blade wrench holder with holes under
the saw base.
Insert Phillips screw through the foot and into the base.
Tighten securely.
TO ATTACh SAw TO MOUNTiNg BOARDS OR
wORK BENCh
See Figure 5, page 18.
The saw should be mounted to a firm supporting surface
such as a workbench or mounting boards. Four bolt holes
have been provided in the feet for this purpose. Secure
using bolts and washers (not included). Bolts should be of
sufficient length to accommodate the saw base, washers,
and the thickness of the workbench or mounting board.
Tighten bolts securely.