Ryobi RB100 - Manual (Page 7)

Page 7
Fig. 1
FEATURES
ON/OFF
SWITCH
FOAM PAD
INSULATED HANDLES
CORD
KNOW YOUR BUFFER/POLISHER
See Figure 1.
Before attempting to use your new Ryobi buffer/polisher,
familiarize yourself with all the safety rules listed in this
Operator's Manual and the operating features shown below.
Cord
6-foot cord.
Insulated Handles
Insulated handles with fitted pistol grip.
Application Bonnet
Re-useable application bonnet made of 100% terrycloth.
Polishing Bonnet
Re-useable polishing bonnet is made of synthetic tufted
material.
Foam Pad
9-1/2 in. (241 mm) pad is 1-3/8 in. (35 mm) thick.
On/Off Switch
Thumb activated for easier operation.
Motor Housing
Always make sure air vents are unobstructed during use.
WARNING:
Do not allow familiarity with your buffer/polisher to make
you careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Your buffer/polisher has a precision built electric motor. It
should only be connected to a power supply that is
120 volts, 60 Hz, AC only (normal household current).
Do not operate this tool on direct current (DC). A substantial
voltage drop will cause a loss of power and the motor will
overheat. If your tool does not operate when plugged into
an outlet, double check the power supply.
MOTOR HOUSING