Ryobi CB120L - Manual

Always mention the above model number when communi-
cating with us regarding battery pack.
Use battery pack for Ryobi cordless products only. Refer to
the Operator’s Manual provided with product.
safety rules
 for best results, your battery tool should be charged
in a location where the temperature is more than
50°f but less than 100°f. To reduce the risk of serious
personal injury, do not store outside or in vehicles.
 under extreme usage or temperature conditions,
battery leakage may occur. If liquid comes in contact
with your skin, wash immediately with soap and water.
If liquid gets into your eyes, flush them with clean
water for at least 10 minutes, then seek immediate
medical attention. Following this rule will reduce the risk
of serious personal injury.
 save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If you
loan someone this tool, loan them these instructions also
to prevent misuse of the product and possible injury.
WarNING!
read aNd uNderstaNd all INstructIoNs.
Failure to follow all instructions listed below, may result
in electric shock, fire and/or serious personal injury.
 Battery tools do not have to be plugged into an
electrical outlet; therefore, they are always in
operating condition. Be aware of possible hazards
when not using your battery tool or when changing
accessories. Following this rule will reduce the risk of
electric shock, fire, or serious personal injury.
 do not place battery tools or their batteries near fire
or heat. This will reduce the risk of explosion and possibly
injury.
 do not crush, drop or damage battery pack. do not
use a battery pack or charger that has been dropped
or received a sharp blow. A damaged battery is subject
to explosion. Properly dispose of a dropped or damaged
battery immediately.
 Batteries can explode in the presence of a source
of ignition, such as a pilot light. To reduce the risk of
serious personal injury, never use any cordless product
in the presence of open flame. An exploded battery can
propel debris and chemicals. If exposed, flush with water
immediately.
 do not charge battery tool in a damp or wet location.
Following this rule will reduce the risk of electric shock.
 recommended chargers:
Model cHarGer
CB120L (130503001, 130503005) CH120L (140503001)
C120D (140109001)
12 volt lItHIuM-IoN
Battery pack
cB120l
(130503001
130503005)
operatIoN
Battery protectIoN features
Ryobi One+ 12 V lithium-ion batteries are designed with
features that protect the lithium-ion cells and maximize
battery life.
If the tool stops during use, release the trigger to reset and
resume operation. If the tool still does not work, the battery
needs to be recharged.
cHarGING tHe Battery pack
Battery packs for this tool are shipped in a low charge
condition to prevent possible problems. Therefore, you
should charge them until the green LED on the front of the
charger comes on.
Charge Time: 40 minutes
cHarGING a cool Battery pack
If the charger does not charge the battery pack under normal
circumstances, return both the battery pack and charger
to your nearest Authorized Service Center for electrical
check.

Charge only with recommended charger.
 Make sure the power supply is normal household voltage,
120 volts, ac only, 60 Hz.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
charger before beginning operation.
 Connect the charger to the power supply.
 Press down on the battery pack to be sure contacts on
the battery pack engage properly with contacts in the
charger.
Note: After charging is complete, the green LED will
remain on until the battery pack is removed from the
charger or charger is disconnected from the power
supply.
 The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.