Ryobi P130 - Manual (Page 6)

6
OPERATION
WARNINg:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNINg:
Always wear safety goggles or safety glasses with side
shields when operating tools. Failure to do so could re-
sult in objects being thrown into your eyes, resulting in
possible serious injury.
APPLICATIONS
You may use this charger for the following purposes:

Portable charging of Ryobi 7. Volt-18.0 Volt batteries.
CAUTION:
If at any point during the charging process none of the
LEDs are lit, remove the battery pack from the charger
to avoid damaging the product. DO NOT insert another
battery. Return the charger and battery to your nearest
service center for service or replacement.
LEd FUNCTIONS OF CHARgER
LEd WILL bE ON TO INdICATE STATUS OF
CHARgER ANd bATTERy PACK:
See Figure 2.

Red Power LED on = Charger is getting power from
cigarette lighter receptacle or powerpoint.
 Red LED on = Quick charging mode.
 Green LED flashing = Charging
 Green LED on = Fully charged and in maintenance charge
mode.
 Red LED flashing = When battery pack is inserted into
charger, indicates hot battery pack or that battery pack
is out of normal temperature range or is evaluating.
 Yellow LED on and Red LED flashing = Deeply discharged
or defective battery pack.
 Yellow LED flashing = This is a High and Low input voltage
shutdown. If the cigarette adapter plug voltage is above
15Vdc or below 10Vdc the charger will stop charging. If
input voltage is between 10.5Vdc and 10Vdc, the yellow
LED will flash and alarm will sound.
NOTE: There is a low input voltage audible alarm for less
than 10.5V DC input. The yellow LED will flash. You should
start your car to recharge the vehicle battery and/or remove
the charger adapter plug to stop the charging before the
car battery is completely drained.

No LED on = Defective charger or battery pack.
ASSEMbLy
UNPACKINg
This product has been shipped completely assembled.

Carefully remove the charger and any accessories from
the box. Make sure that all items listed in the packing list
are included.
 Inspect the charger carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-55-579 for assistance.
PACKINg LIST
In-Vehicle Charger
Operator’s Manual
WARNINg:
If any parts are missing or damaged do not operate this
tool until the missing parts are replaced. Failure to do so
could result in possible serious personal injury.
WARNINg:
Do not attempt to modify this tool or create accesso-
ries not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.