Petsafe Ultralight Sonic Bark Control Collar - Manual (Page 3)

3
STEP 1 BATTERY ACTIVATION
The battery module is installed in your UltraLight Sonic
Bark Control unit. A removable protective film on the
contact side of the battery prevents activation of the unit.
Introduce your dog to the bark control unit as described in
the training manual before removing the protective film.
To remove the battery, insert a coin in the slot on top of the
battery module, push down slightly and turn counter-clockwise.
Flip battery to contact side. To remove the protective film, lift
the red tab and peel off the film.
To re-install battery, align the arrow on the battery module with the triangle
on the unit. Using a coin, push down and turn clockwise, until the arrow on
the battery module lines up with the "Lock" on the unit.
Battery life is dependent on the number of corrections your dog receives, but
on average the life should be 1 month.
STEP 2 TEST UNIT
Hold your finger over the speaker to muffle the sound
when testing the unit. Blow across the microphone.
The unit should emit a sharp sound. If you do not
hear a tone – check the battery and repeat the test.
microphone speaker