Petsafe Elite Big Dog Bark Control - Manual (Page 5)

www.petsafe.net 5
The system has 10 levels of static correction. It begins with low-level corrections, however, if
excessive barking continues the correction intensity will increase with each successive bark
until the barking stops. Once the dog has learned to reduce the barking, the initial warning
corrections are reduced. As a built-in safety feature, if your dog barks 15 times or more within a
1 minute 20 second period, the Bark Control Collar will automatically shut off for 3 minutes.
Key Definitions
Two Color LED: Shows good or low battery.
Sound Activated Sensor: Detects the sound of your dog’s bark.
Contact Points: Deliver the static correction.
Sensor Probe: Detects the vibrations of your dog’s barking. Note:
The Sensor Probe is not adjustable.
Fit the Bark Control Collar
Important: The proper fit and placement of your Bark Control Collar is important for
effective operation. The Contact Points must have direct contact with your dog’s skin on
the underside of his neck.
To assure a proper fit, please follow these steps:
1. Make sure that the battery is in the “OFF” position.
2. Have your dog standing comfortably (
A).
3. Center the Contact Points underneath your dog’s neck, touching
the skin ( B).
Note: It is sometimes necessary to trim the hair around the Contact
Points to make sure that contact is consistent.
Do not shave the pet’s neck as this may
increase the risk of skin irritation.
4. Check the tightness of the Bark Control Collar by
inserting one finger between a Contact Point and
the dog’s neck ( C). The fit should be snug but not
constricting.
5. Allow your dog to wear the collar for several minutes,
then recheck the fit. Check the fit again as your dog
becomes more comfortable with the Bark Control Collar.
Sound Activated
Sensor
Sensor Probe
Contact Points
Two Color LED
SÍ
NO
A
B
C