Petsafe Deluxe In-Ground Cat Fence™ Extra Receiver Collar - Manual (Page 19)

www.petsafe.net 19
Short Loop Test
The Short Loop Test is a simple test to determine if each component (Fence Transmitter,
Receiver Collar and Boundary Wire) is functioning properly.
1. Disconnect the Boundary Wire and Ground Wire.
2. Cut approximately 10 feet of unused Boundary Wire and connect it to the Boundary Wire
Terminals.
3. Spread the Boundary Wire out into a circle. Set the Boundary Control Switch to B.
4. Set the Boundary Width Control knob to 10 and the Static Correction Level to 2 or above.
5. If the Loop Indicator Light is not lit, then your Fence Transmitter is not functioning properly.
Contact the Customer Care Center at 1-800-732-2677.
6. If the Loop Indicator Light is lit, disconnect one end of the Boundary Wire from the
Boundary Wire Terminal.
7. If the loop alarm does not sound, the Fence Transmitter needs to be replaced. Contact the
Customer Care Center at 1-800-732-2677.
8. If the loop alarm does sound, plug the Boundary Wire back into the Boundary Wire Terminal.
9. Hold the Receiver Collar next to the 10 foot length of Boundary Wire. The Receiver Collar
should beep about 1 foot away from the Boundary Wire.
10. Hold the Test Light contacts to the Contact Points. The Test Light should fl ash when you
hold the Receiver Collar close to the Boundary Wire.
11. If Receiver Collar does not beep and the Test Light does not fl ash, replace the battery in
the Receiver Collar. If it still does not beep and the Test Light does not fl ash, contact the
Customer Care Center at 1-800-732-2677.
12. If the Receiver Collar beeps, there may be a complete or partial break in the Boundary Wire.