beautypg.com

Reset the receiver collar – Petsafe 250 m Remote Trainer User Manual

Page 12

background image

12

www.petsafe.net

Reset the Receiver Collar

To reset the Receiver Collar to work with a new Remote Transmitter or to reprogram a
new Receiver Collar to work with your existing Remote Transmitter:

1. Turn the Receiver Collar off.
2. Press and hold the On/Off Button until the Receiver Indicator Light comes on solid

green and the Receiver Collar beeps 5 times.

3. Continue to hold the On/Off button until the Receiver Indicator Light has turned off.
4. Press and hold the Upper Button on the Remote Transmitter until the Receiver

Indicator Light fl ashes 5 times and beeps 5 times. You may need to hold both units
0.5-1 m from each other before this occurs. Once the Receiver Indicator Light has
fl ashed 5 times, the Receiver Collar has been reset. If the Receiver Indicator Light
does not fl ash 5 times, start again and repeat the process.

_____________________________________________________________

Program the Receiver Collar for Two or
Three-Dog Operation

With the Transmitter set to Mode 3 or 4, PetSafe

®

Receiver Collars can be set to

respond to the upper, lower, or side Remote Transmitter buttons. Add-A-Dog

®

receiver(s) must be purchased to train additional dogs.

1. Program the Remote Transmitter to Mode 3 or 4.
2. Program the fi rst Receiver Collar.

A. Turn the Receiver Collar off.
B. Press and hold the On/Off Button. The Receiver Indicator Light will come on,
then turn off in 4-5 seconds. If the On/Off Button is released too early, the Receiver
Indicator Light will begin its normal fl ashing. If this occurs, start over and repeat
the process.
C. After the Receiver Indicator Light has turned off, release the On/Off Button.
D. Press and hold the Upper Button on the Remote Transmitter until the Receiver
Indicator Light fl ashes 5 times. You may need to hold both units 0.5-1 m from each
other. If the Receiver Indicator Light does not fl ash 5 times, start over and repeat
the process.

3. Program the second Receiver Collar using A. through D. above, but using the Lower

Button in place of the Upper Button.

4. Program the third Receiver Collar using A. through D. above, but using the Side

Button in place of the Upper Button.

Step

6

Step

7

400-1158-19.indd 12

400-1158-19.indd 12

9/25/09 10:41:05 AM

9/25/09 10:41:05 AM