PDR Mounts pdm625t-11 - Manual (Page 4)

1. FASTEN MOUNTING PLATE TO WALL
Fig 2
2. SECURE THE DISPLAY BRACKETS TO THE MO NITOR
NOTE: Do not over tighten the bracket mounting screws as damage to the display internal mounting threads could occur.
The bracket must be secured to the wall studs capable of at least (4) times the weight of the unit. The wall bracket should be mounted at the same horizontal center line
as the display center line ( viewing horizontal center line). Using the six lag bolts( E ) and washers supplied ( D ), level and secure the mounting plate to the center of
the wall studs. Pre drill 3/16” (5mm) hole for lag bolts
Fig.2
Lay the display panel face down on a protected surface. Position the left and the right hand brackets ( A ) with the slots facing towards the top.
See
Fig.3. Note bottom edge! Using the proper screws and square multi-mount washers supplied, position the brackets equal distance from
top to bottom and tighten hardware.
FLOOR LINE
VIEWING
HORIZONTAL
CENTER LINE
WOOD STUDS
(std construction 2 x 4 studs/1/2” wallboard)
EQUAL
SPACING
32"
16"
Fig 3
4
Mounting hardware F,G,H,K,L,M
Square Multi-mount washer (J )
Panel display bottom edge
Display bracket ( A ) left
Plastic spacer ( I )
Display bracket ( A ) right
4”
47 ½”