Outdoor Great Room CNG-Traveler Gas Grill User Manual
Page 15

The Outdoor GreatRoom Company • Cook Number Grill CNG-TRAVELER Gas Grill • Rev. A
15
CAUTION: Be sure the grill is OFF and cool before cleaning.
Annual Cleaning of The Grill Interior
Burning-off the grill after every cookout will keep it ready
for instant use. However, once a year you should give the
entire grill a thorough cleaning to keep it in top operating
condition.
Follow these steps:
1. Turn all control knobs and OFF/ON switch to the full
OFF position.
2. Detach the LPG cylinder by turning the Quick Coupling
Nut of the connection tube counterclockwise.
3. Remove the grilling grate, searing plate, and grease
drawer with its aluminum tray. Wash each item with a
mild soap and warm water solution, rinse thoroughly
and let dry.
4. Cover burner orifice with aluminum foil.
5. Brush the inside and bottom of the grill with a stiff wire
brush, and wash with a mild soap and warm water solu-
tion. Rinse thoroughly and let dry.
6. Remove aluminum foil from orifice and check orifice for
obstruction.
7. Check spark electrode, adjusting as needed. The Elec-
trode tip should be pointing toward the burner ports
approximately 1/8 inch from the burner surface. (See
Figure 13).
WARNING
Cleaning Exterior Surfaces
Before initial use, and periodically thereafter, wash the grill
using a mild soap and warm water solution. Use a wash
cloth or sponge for this process. Do not use a stiff wire or
brass brush that might remove paint during the cleaning
process.
8. Reconnect the gas source and observe the burner
flame for correct operation.
9. Re-install the searing plate, grilling grate and grease
drawer with its aluminum tray.
Figure 13
Fire Risk
Explosion Risk
Do not line the bottom of the grill housing with alumi-
num foil, sand or any substance that will restrict the
flow of grease into the grease drawer and obstruct air
flow.
• Failure to comply with these instructions could re-
sult in a fire or explosion which could cause prop-
erty damage, serious bodily injury or death.
Spark Electrode
Burner