Night Optics Panther 336 Thermal Riflescope (336x256 | 50mm) - Manual (Page 11)

The “Reticle Settings” menu controls the reticle position parameters, color and type on the display
of the riflescope. Press and hold the “Menu button (fig. 6-1)” to enter the menu system. “Reticle
Settings” is the first option. Tapping the ”Menu button” again will advance into the sub-menu where
addition options are available.
RETICLE SETTINGS
To adjust the reticle type or turn off the reticle, enter the “Reticle Settings” menu, advance into the
Reticle Type menu screen, and use the directional buttons (fig. 6-2, 3) to select: NO RETICLE,
CROSS HAIR or MIL-DOT and press (fig. 6-1) to select the desired option. Reticles can be
programmed into the system, however the reticles supplied by default are the most commonly
used. If a custom reticle is desired, contact a Night Optics customer service associate for
assistance.
RETICLE TYPE
To adjust the reticle type or turn off the reticle, enter the “Reticle Settings” menu, advance into the
Reticle Color menu screen, and use the directional buttons (fig. 6-2, 3) to select: GREEN, RED,
YELLOW, WHITE and BLACK and press (fig. 6-1) to select the desired option.
RETICLE COLOR
See “Zeroing the Riflescope” on page 9 to learn more about this feature.
WINDAGE AND ELEVATION
To adjust the color palette type or turn off all color settings, enter the “Color Scheme” menu,
advance into the Color Scheme options screen, and use the directional buttons (fig. 6-2, 3) to
select: NO SCHEME, RED-GREEN, RED-BLUE, SPECTRUM 1, SPECTRUM 2, SPECTRUM 3
or BLACK-YELLOW and press (fig. 6-1) to select the desired option.
The “Color Scheme setting works with the polarity options White Hot, Black Hot and a 3rd Option.
See ”Menu System / Select / Polarity” on page 7 to learn more about the polarity feature.
COLOR SCHEME
OPERATION
10
MIL-DOT CROSSHAIR
FIGURE 9: Reticle types
1 cm = 0.3937 in
1 meter = 100 cm
1 meter = 3.281 ft
100 meters = 109.4 yds