Night Optics D-930 Gen 3 Gated Clip-on Night Vision Scope - Manual (Page 11)

OPERATING PROCEDURES
• Make sure the power switch is in the OFF position.
• Install battery as stated in directions
• Attach the device before objective of daytime scope as stated in directions
• Turn device ON and make sure device is working properly.
• Adjust focus accordingly.
WARNING
Do not turn the device ON during daytime without the protective lens
cap/daylight filter on.
MOUNTING PROCEDURES
• Attach proper scope adapter to Objective Lens.
• On the scope, loosen the NO/D-930 Dioptic Ring Fastener.
• While holding the scope in place, attach the the NO/D-930 by turning the device or Dioptic
Ring counter-clockwise until tight.
• Secure the scope by tightening the Dioptic Ring Fastener.
• Adjust the NO/D-930 focus adjustment knob for a sharper image.
• Adjust Gain if necessary according to light conditions.
IR ILLUMINATOR MOUNTING
(Optional)
• Mount the 1913 Weaver Rail onto the NO/D-930.
• Turn tightening screw until mount is secure.
• Mount IR Illuminator onto 1913 Weaver Rail.
• Tighten screw until Illuminator is secure.
• Adjust IR focus accordingly.
WARNING
The IR Illuminator is a light that is invisible to the unaided eye for use
during conditions of extreme darkness. However, the light from the
illuminator can be detected by using night vision equipment.
9