MK Diamond MK-101 Lowes - Manual (Page 24)

24
(D)
Verify proper cooling flow on both
sides of the blade (See Maintenance
Section to increase/decrease flow)
CUTTiNG STRaiGHT eDGeS
MK-101 OPeRaTiON
DO NOT FORCe THe TOOl. It will do the job better and safer at the rate for
which it was designed.
CaUTiON
(A)
Loosen the Adjustable Cutting
Guide retaining thumbscrew
DiaGONal CUT
DO NOT FORCe THe TOOl. It will do the job better and safer at the rate for
which it was designed.
CaUTiON
(A)
Position the Dual 45° Flat
Angle Guide and tighten the
retaining thumbscrew
(B)
Position the tile against the
Dual 45° Flat Angle Guide and
the Ruler/Stop
(C)
Verify proper cooling flow on both sides
of the blade (See Maintenance Section
to increase/decrease flow)
To cut diagonal, the Dual 45° Flat Angle Guide (MK Diamond Part No. 134557-MK)
should be used.
NOTe:
(C)
Place the tile against the Ruler/
Stop and Cutting Guide. Turn
the motor ON.
(E)
Perform the cut. Turn the motor
OFF when work is complete.
(B)
Position the Adjustable Cutting
Guide to desired cut length indicat-
ed inside the diamond and tighten.