Magnum Dynalab MD-105T - Manual (Page 4)

- 4 -
UNPACKING YOUR 105T
Carefully inspect all sides of the shipping carton for damage. If there are marks or
holes in the carton make note of the location in relation to the unit inside. Any
obvious dents or scuff marks should alert you to the possibility of damage.
Carefully remove the MD 105T from the end caps and wrapping, inspect all
sides. Pay special attention to the corresponding areas on the unit where damage
was found to the shipping carton. If damage is evident, document the type and
extent of the damage, then repack the unit and call the dealer.
KINDLY DO NOT SEND THE UNIT BACK TO THE SHIPPER UNTIL YOU HAVE BEEN
ASKED TO DO SO.
DO NOT DISCARD THE PACKING MATERIALS AND CARTONS. Should there be a
necessity to return the unit for any reason, it must arrive safely and suitably
packaged in order for our receiver to accept it from the carrier. Also, if the unit
has incurred damage as a result of improper packaging, it is not likely that a
claim for the damage against the carrier will be successful.
Likewise, we will ship your unit back to you only in factory-approved packaging,
However, if the unit were to arrive at the factory in anything other than factory
approved packaging, we reserve the right to return the product in factory-
approved packaging and charge the cost of the packaging to the shipper. This is
the only way we can assure your unit of a safe return (damage by carrier
excepted).