Magnum Dynalab MD-105T User Manual
Page 11

- 11 -
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
No sound, meter
lights are not on
• Power cord
disconnected
• Power off at source
• Connect power cord
• Check AC source
No sound, meter
lights are on
• Interconnect not
properly installed
• Preamp set to
incorrect source
• Power amplifier is
off
• Tube failure
• Verify installation of interconnects
• Turn preamp to input where tuner is
connected
• On preamp defeat tape monitor
function
• Turn amplifier on
• Replace 6922 tube
Low signal
strength
• Antenna not
connected properly
• Incorrect antenna
Station too distant
• Improper antenna
position/
placement
• Check antenna connection
Check instruction manual for correct
antenna type
• Change your antenna
• Rotate your antenna or mount your
antenna higher or near a window if
indoors
Intermittent
sound
• Mute switch is in
the “ON” position
• Turn the mute switch to “OFF”
position
Tuner remote
does not work
• Batteries dead
• Buttons being held
too long
• Improper sequence
• Power switch should be in the off
position on standard tuners and the
remote must be activated with the
“Tuner Remote” power button on
the hand held.
• All stations must be stored and
recalled with a two digit code from
01-20.
• To store a preset press the “store”
button then the two digit preset.
Touch the buttons very quickly and
lightly.
• To recall, touch “Preset” and then
the two numbers you want to recall
very quickly.
• Make sure to turn the unit off with
the remote control “Tuner Remote”
after storing as this will save the
stations to the flash memory.