Magnum Dynalab MD-108T - Manual (Page 11)

- 11 -
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
No sound, meter
lights are not on
• Power cord
disconnected
• Power off at source
• Fuse blown
• Connect power cord
• Check AC source
• Check fuse
No sound, meter
lights are on
• Interconnect not
properly installed
• Preamp set to wrong
source
• Bandwidth switch not
activated
• Power amp off
• Tube failure
• Check installation of
interconnects
• Turn preamp to tuner
• Activate one of the
bandwidth switches
• Turn on amp
• Replace tubes (MD
Reference 6922)
Signal strength is
low
• Antenna not connected
• Wrong type of antenna
• Station too far away
• Antenna pointed the
wrong way
• Check antenna hookup
• Check instruction
manual for types of
antennas
• Change your antenna
• Rotate the antenna to
point at the station
Reception is poor
• Antenna not connected
• Wrong type of antenna
• Cross talk from
neighboring stations
• Multi-path is occurring
• Antenna switch on
wrong setting
• Check antenna hookup
• Check instruction
manual
• Switch to narrow setting
on IF bandwidth
• Rotate your antenna,
read the Reception
Techniques
• Check antenna input
setting
Intermittent sound
• Mute switch is on • Turn mute switch off