Bradford White DS1-50S6FSX - Manual (Page 23)

23
Optional Vent-Air Intake System Installations continued-
Figure 19
10. Mark the mounting screw hole locations for the backing plate. Rotate the
backing plate in order to gain access to the markings. With a 3/16 inch
diameter drill bit (not supplied), drill holes for the supplied wall anchors.
Install the wall anchors and secure the backing plate to the wall with four
(4) #10 x 1 inch screws (supplied). (See Figure 20). Note: Certain
construction of walls may require the use of a different type of anchoring
means than supplied.
Figure 20