Carson SA-430-17 - Manual (Page 5)

SA-430-17 Installation and Operating Instructions Page 5 of 16
03/31/10 CP5010B
INSTALLATION
Proper installation of the unit is essential for years of safe, reliable operation. Please read all
instruction before installing the unit. Failure to follow these instructions can cause serious
damage to the unit or vehicle and may void warranties.
SAFETY PRECAUTIONS
For the safety of the installer, vehicle operator, passengers and the community please observe
the following safety precautions. Failure to follow all safety precautions and instructions
may result in property damage, injury or death.
Qualifications - The installer must have a firm knowledge of basic electricity, vehicle electrical
systems and emergency equipment.
Sound Hazard - Sound level from siren speaker (>120dBA @ 10 feet) may cause hearing damage.
Do not operate siren without adequate hearing protection for you and anyone in immediate vicinity.
(Ref. OSHA 1910.95 for occupational noise exposure guidelines)
Mounting - Mount the control head for easy access by the vehicle operator. DO NOT mount
in air bag deployment area. Assure clearances before drilling in vehicle.
Wiring - Use wiring capable of handling the current required. Make sure all connections are
tight. Route wiring to prevent wear, overheating and interference with air bag deployment.
Install and check all wiring before connection to vehicle battery.
Testing - Test all siren functions after installation to assure proper operation. Test vehicle
operation to assure no damage to vehicle.
Keep These Instructions - Keep these instructions in the vehicle or other safe place for future
reference. Advise the vehicle operator of the location.
UNPACKING
Inspect contents for shipping damage. If found alert carrier immediately.
Contact supplier immediately if any components are missing.
Contents should include the following items:
Complete Unit
Qty Item -17F -17FX
1 Amplifier, Remote (SA-430-17F or FX) X X
1 Bracket, Microphone Clip with mounting screws (CP3633) X X
1 Connector, 10-P Terminal Block Plug for Amplifier (CP4833-10) X X
1 Cable Assembly for Control Head, 5-P (CP3040) X X
1 Control Head with attached Microphone (SA-430-17CH) X
1 Control Head without Microphone (SA-430-17CHX) X
1 Cable, Microphone Extension 18FT (CP3850) X
1 Microphone, Detachable Noise Cancelling (ES00028-10) X
1 Instruction Manual (CP5010 This Manual) X X
Amplifier Only
Qty Item
1 Amplifier, Remote Only (SA-430-17AMP)
1 Connector, 10-P Terminal Block Plug for Amplifier (CP4833-10)
1 Instruction Manual (CP5010 This Manual)