Christie Digital Systems High Performance Xenon Lamp CDXL - Manual (Page 14)

13 S A F E T Y I N F O R M A T I O N
Warning
Do not operate the lamp in close proximity to paper, cloth or
other combustible material, nor cover it with such materials, even
immediately after it is turned off. Otherwise it could cause a fire.
As the lamp is filled with high pressure xenon gas, do not hit the
lamp against anything, apply excessive stress or scratch the lamp.
Otherwise it could cause an injury if it bursts.
The lamp must be operated in a splinter-scatter-proof lamp
house. Do not open the lamp house while the lamp is operating or
immediately after it is turned off. Otherwise it could cause an injury
if it bursts.
Do not touch the lamp while it is operating or immediately after it
is turned off because it is extremely hot. Otherwise it could cause
a burn.
Do not operate the lamp in an atmosphere containing an inflammable
substance, such as gasoline, spray containing volatiles, thinner,
lacquer or dust. Otherwise it could cause a fire or an explosion.
As the lamp is filled with high pressure xenon gas, it must be kept in
the provided protective case when transporting, storage or disposal.
Otherwise it could cause an injury, if it bursts.
The lamp that has been used for the rated service life is more likely
to break and burst because of the deteriorated glass condition.
Therefore, follow the instructions in this leaflet for replacement and
disposal of the used lamp. Otherwise it could cause injury if it bursts.
Wear a protective mask, protective gloves and a thick long-sleeved
shirt, when the lamp is handled or installed and removed to/from
the lamp house.
The protective mask which covers the carotid, must be made with
thicker than 2mm polycarbonate or another material with same
strength or more.
Gloves and a thick long-sleeved shirt must be made with ripping-
proof and piercing-proof material like aramid fiber. Otherwise it could
cause an injury if the lamp bursts.
Operate the lamp in the position indicated in the column of the
burning position in this certificate. Otherwise it could cause
overheating of the lamp house, lamp breakage or short lamp life.
Thoroughly ventilate the area or the room when operating the lamp in
an oxygen atmosphere (in air), except in the case of ozone-free lamps.
If ozone is inhaled, it could cause headaches, nausea, dizziness, etc.
Turn off the electrical power before installing, removing or cleaning
the lamp house. Otherwise it could cause electrical shock.
During operation the lamp emits intense UV radiation which is harmful
to the eyes and skin. Do not look directly or indirectly at the operating
lamp. Otherwise it could cause eye aches or eyesight problems.
Do not directly or indirectly expose your skin to the lamp light.
Otherwise it could cause inflammation of the skin.
Important operation notes
The lamp must be operated under the specified use conditions such
as lamp current, lamp voltage and cooling condition.
Keep the lamp base temperature below 200ºC or maximum
temperature if specified by following cooling conditions designated.