Zippy RHI-6460P - Manual (Page 15)

1.7 HOT-SWAP PROCEDURES
Please check with the following items at the very beginning against a defective power supply unit.
Locate the defective power supply by examining the indication of the individual LED or the LED on
the front control panel . ( Power unit is defective if LED is extinguished,.)
B) Unplug the power cord of defective power supply unit from AC inlet.
C) Unscrew all mounting screws fixing the defective power supply unit.
D)
Pulling out the defective unit
E) Replace with a new power supply unit .
F) Plug in the power cord.
Check the LED indicators which shows the total power system status. It must be
from FLASHING status to light GREEN or from RED to GREEN color.
OTHERWISE, PLEASE CONTACT your local distributor / agent.
H) Screwing all mounting screws to fix the new power supply unit .
I ) If you want to simulate the defective symptom of a NEW power supply unit, please
refer to Section 1.6 INSTALLATION & TESTING.
15