Zippy RHI-6460P - Manual (Page 10)

1.5 SPECIFICATIONS
PRODUCT SPECIFICATIONS
MODEL RHD/H/I-4400P
400 WATT HIGH PERFORMANCE POWER SUPPLY with ACTIVE POWER FACTOR
CORRECTION
A
INPUT CHARACTERISTICS
1 VOLTAGE FULL RANGE, SINGLE PHASE, 90 264VAC
2 FREQUENCY 47 63HZ
3 INPUT CURRENT 2.5A RMS FOR 230VAC
7A RMS FOR 115VAC
4 INRUSH CURRENT 65A MAX. FOR 115 VAC PER MODULE
125A MAX. FOR 230 VAC PER MODULE
B
OUTPUT CHARACTERISTICS
OUTPUT OUTPUT CURRENT OUTPUT VOLTAGE REGULATION OUTPUT RIPPLE
& NOISE (p-p)
VOLTAGE MIN. MAX. RANGE MIN NOM MAX MAX.
+5V 5.0A 35 A 5% +4.75 +5.00 +5.25 60mV
-5V 0A 0.8A 5% -4.75 -5.00 -5.25 100mV
+12V 2.5A 20A 5% +11.40 +12.00 +12.60 100mV
-12V 0A 1A 5% -11.40 -12.00 -12.60 100mV
TOTAL POWER: 400W (MAX.)
NOISE BANDWIDTH : DC TO 20MHZ.
C
SPECIFICATION
TEMPERATURE RANGE OPERATING 0 40 STORAGE -20 80
HOLD UP TIME 16ms MIN.
DIELECTRIC WITHSTAND INPUT/OUTPUT 1500 VAC FOR 1 minute
INPUT TO FRAME GROUND 1500 VAC FOR 1 minute
HUMIDITY
10 90%RH
EFFICIENCY 70% TYPICAL AT 115V AT FULL LOAD
POWER GOOD SIGNAL ON DELAY 100ms TO 500ms OFF DELAY 1ms
OVER LOAD PROTECTION 110 150% MAX
OVER CURRENT PROTECTION : +5V 44A 60A +12V 29.1A 40.5A
OVER VOLTAGE PROTECTION +5V 5.7V 6.5V +12V 13.6V 15V
EMI: FCC CLASS B , CISPR 22 CLASS B
SAFETY EACH POWER UNIT SHALL BE FULLY COMPLYING
WITH THE UL / CSA / TÜV APPROVAL
ALARM METHOD: 1) AUDIO ALARM 2) FAULT LED INDICATOR
3) POWER DEFECTIVE SIGNAL.
HOT- SWAPPABLE AND HOT- PLUG - IN CAPABILITY
MEET
IEC-1000-3-2 CLASS D (ACTIVE PFC)
10
DIMENSION 213mm*183mm*154mm (D*W*H)